Banner Boots
BOOKER & CO
Banner Boots, white crack leather
Hand-stitched 'X' details
Speed hooks
Bump toe
Waxed cotton wraparound laces
3.5 cm wooden heel
Veg tan leather outsole
The Banner Boot is crafted on the very popular (and super comfy) Luxford Last. Staunch little hand stitched ‘X’ s on the toecap, quarters and back strap give the Banner Boot a tough modern urban appeal. Natural coloured veg tan sole is teamed with a unique hand made wooden heel. Four pairs of black hooks at the top of each boot support super speedy lacing. The waxed cotton laces are long enough to wrap around the vamp a couple of times (pictured) if you like a considered layered look, otherwise it’s totally ok to lace them in the traditional way too!
Lined with black sheep leather and featuring a fully cushioned leather insole of hardworking memory foam under the leather sock. In keeping with our commitment to slow fashion the 4mm thick Veg Tan leather outsoles on these boots are resole-able.
Crafted on a C width last for that extra bit of comfort-inducing-width in the toe region.
These boots have been designed, patterned, prototyped and tested in Melbourne by Karen Booker.
Additional Info
These shoes are sized to fit the modern woman's foot. This means these shoes will not crush your feet but gently encapsulate them.
If you are unsure of what size to order have a look at our chart.
To achieve the most accurate fit you should measure your feet and compare your measurements to the chart, alternatively email us through the measurements and we can select the size that we think will fit you best.
How to measure your feet
Place a piece of paper on a hard floor (not carpet), against the wall.
Stand barefoot on the paper with your heel hard against the wall, legs straight with feet hip width apart.
Make sure the paper has not shifted and is still flat and against the wall.
Draw a line on the paper at the very end of your longest toe.
Measure the distance between the edge of the paper that was against the wall and the line you drew.
Measure it again to double check the measurement.
Do this again with the other foot.
